What sits between the main and the tray in Salisbury
The City of Salisbury runs its own water supply, so the Charlotte hardness numbers are not the ones that apply here and the dishwasher reasoning is checked against the city report first. Duke for power. In housing of this age the electrical service is the standing constraint: the wiring has been renewed in stages by various people over a century, and what is modern at one socket is not necessarily modern at the panel, which is worth establishing before adding load.
Which is the right place to start, because an ice maker is the far end of a water supply and the fault is almost always somewhere along that route rather than at the end of it. There are five things between the mains and the ice tray, and four of them fail more often than the module does.
- The tap on the supply pipe. Frequently a saddle valve, which is a self-piercing fitting clamped onto a pipe with a needle that makes its own hole. They corrode, the seat perishes, and they clog or seep. Because almost nothing here has a basement, that valve is often on a crawlspace pipe where nobody looks.
- The line itself, usually quarter-inch, and frequently crushed by an appliance pushed too hard against the wall. Sometimes the repair is moving the refrigerator forward two inches.
- The inlet valve, holding against static pressure that runs well above 100 psi across much of this metro, every hour the appliance is not filling.
- The fill tube, which ices up. A plug of ice forms, the module cycles perfectly, calls for water and receives none. This is the most misdiagnosed fault on the appliance: the module works, the module gets replaced, and the new one does exactly the same thing a fortnight later.
- The module, which is genuinely the fault roughly one call in four.
Two free checks before any of that. The bail arm, the wire that shuts production off when the bin is full, gets parked by accident constantly. And the freezer temperature, because most ice makers will not cycle above about 10F, so a defrost fault stops ice production while everything else looks normal.
It is worth saying where this page sits commercially. Ice maker repair carries the highest cost-per-click of any term on this site at $58.82 against ten searches a month, and a bid that high on a term that small means the margins are good. They are good because modules get fitted at a healthy price on faults a fill tube clearance would have resolved. We would rather say that than benefit from it quietly in Salisbury or anywhere else.
The commercial position is the same in Salisbury as it is at a Charlotte address, because the rate card on this site is not a Charlotte rate card. The diagnostic visit is $89 and it comes off the invoice in full when you approve the repair. Labour beyond that is $95 to $145 an hour. Nothing is added for the drive, and if the same fault returns after we have fixed it the return visit carries no fee at all.
What Salisbury itself changes
The kitchens in Salisbury
Salisbury holds one of the most substantial historic housing stocks in North Carolina, across the Salisbury Historic District, North Main Street from roughly 1900 to 1930, Brooklyn-South Square and North Long Street-Park Avenue, in Late Victorian, Colonial Revival and Craftsman bungalows in real quantity. For appliance work that produces a specific and unglamorous problem: this is the hardest town in the service area to physically get an appliance into or out of. Original door openings, narrow stairs, interior routes with several turns, and kitchens at the back of houses that were designed around a service arrangement nobody uses now.
What is actually installed
A century of accumulation. Appliances fitted into spaces adapted for them, connections dating from whenever each appliance was installed, supply lines extended to reach positions that suited the room rather than the plumbing, and dryer ducts routed through whatever was available. In a house of this age the connection behind the appliance is worth more attention than the appliance itself, and it is frequently where the fault turns out to be.
Getting an appliance in and out
The defining feature of working in this town, and it changes the economics of a repair. A refrigerator that came into one of these houses twenty years ago may not come out of it now, because a door has been replaced, a wall has been built, or the appliance was carried in before something else was fitted. Where that is the case a repair is not competing with a replacement on price, it is competing with a replacement that may not be practical at all. We establish the route before recommending either.